About the 5/8″ Front Side Multi-Tool Holder
The front side, multi-tool holder was designed to complement our four position, gang-tooling tool posts (P/N 5930 or P/N 5931). It can be used in conjunction with the gang-tooling tool post, or on its own for our customers who want to convert their Sherline lathe into a “Chucker Lathe” or gang-tooling lathe.
Our front side, multi-tool holder offers a convenient and accurate way to hold up to two, round boring tools, and a slot for holding turning, grooving or threading tools. This tool post has (2) 3/8″ holes to hold boring bars, drill chucks, or tool bushings, and a slot to hold a 3/8″ lathe cutting tool with two locking screws for each tool.
For customers who want to use ER16 collet holders with a 5/8″ shank, we offer P/N 97-5937 which is the same as this tool holder except it has 5/8″ tooling holes.
Includes the following:
- 3/8″ Front Side Multi-Tool Post Body
- 10-32 x 1″ SHC Screw (2)
- Extended Tool-Post T-Nut (2)
- 10-32 x 3/4″ SHC Screw (6)
- #10 Washer (2)
- Steel Dowel Pin 1/4″ x 3/4″ (2)
Considerations Regarding this Tool Holder and Its Possible End Uses
There are many considerations regarding this tool post and its possible end uses. Please check the instructions for a complete list.
- Additional Information